Rcom PRO 20 Manuel d'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
K5H9F
Fklfnhq


:FCBH
8F5=B
5IHC9@9L7C" @H8"
This is a naturally occurring phenomenon when there is a
significant difference in temperature between inside and
outside of the incubator during incubation period. If this occurs,
water may form in inside bottom of the main body of the
incubator(bottom part).
Maintenance after Hatching
Dew Condensation
Humidity & Air Maintenance During Incubation
When hatching, humidity should be relatively high to prevent
the thin membrane from drying out or hardening before hatching.
When hatching, it's recommended not to open the lid often.
This is because if you open the lid often humidity will be rapidly
decreased and it will take a long time to regain the proper humidity.
It's very important to maintain humidity higher 1~2 days before
hatching than the early and middle incubation periods. Humidity
requirements during incubation are RH 45~55% for waterfowl,
RH 40~45% for poultry and RH 35~45% for parrot, in general.
One day before hatching, all kinds of birds need about RH 65%
humidity and sometimes need higher than that.
However, in areas of high ambient humidity, lower levels of
humidity may be needed during incubation.
Incubator internal temperature is 37 (99.5) or more, and
hatching room temperature is below 28, in that case, RH 70%
humidity is may not be able. The difference of ±5% humidity
value may occur from the humidity sensors difference, and there
are no problems at hatching
It's very important to keep humidity higher than RH 60%
before hatching 3days.
K5H9F
Fklfnhq


%*(*5"-*/$6#"503
53
5. Incubation
(1) Humidity & Air Maintenance during Incubation /
Maintenance after Hatching
(2) Dew Condensation
As there is some difference in chick feed for each kind of bird, so it's desirable to obtain useful information
about the chicks before hatching.
Be sure to use a three-wavelength 20W bulb. If you
use a bulb over 20W. temperature goes up, possibly
killing the chick or causing a fire. If there is too much
water and a chick would falls into water, its feathers
get wet and it can be died of loss of body heat. Here,
dry feathers with a hairdryer. etc
Be sure to use a three-wavelength 20W bulb :
In case breeding room size 370 x 270 x 130(mm)
Hatcher : The machine for egg-hatching. Operate it 1~3 days before egg-hatching. (Rcom MARU H&B)
Brooder : The machine makes baby chickens or birds warm up against cold or cool environment. You can
set up proper temperature and humidity. (Rcom MARU H&B / Rcom Brooder Series)
Please do not try to egg-hatching in the incubator. It makes your incubator broken or faulty, and we do not
give you free warranty service. (Please move all the eggs 1~3 days before hatching into Hatcher or Brooder.)
It is necessary to use a brooder for baby chicken or bird since they are too week against cold or cool environment.
If you try egg-hatching in your incubator, there would be lots of germs, feathers, which causes of low egg hatching
possibility for your next hatching. Also, they can make your incubator broken or faulty.
We strongly recommend you to use independent Hatcher or Brooder for egg-hatching.
If you have any faulty or broken because of not using independent Hatcher or Brooder, we do not serve you the
free warranty service. In other words, you have to pay for the service charge.
To make a simple Hatcher or Brooder, please refer to the our web-site (www.Rcom.co.kr).
K5H9F
When the baby chickens hatch out,
please move them into a brooder.
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire